Delfield Error Codes
What Delfield fault codes and alarms mean, and what a technician checks for each one. Need it fixed? We repair Delfield equipment across the Charlotte area.
Danfoss display (6000XL, Specification Line)
| Code | Meaning | What to check |
|---|---|---|
| E-1 | Box temperature sensor open/shorted or control faulty | |
| E-2 | Coil temperature sensor open/shorted or control defective | |
| E-6 | Defective potentiometer in unit control | |
| E-13 | Loose display-to-controller cable, or faulty display/control |
ERC2 display (6000, ACR, Spec Line)
| Code | Meaning | What to check |
|---|---|---|
| Er 1 / Er 5 | Software or hardware failure | Reset; if persists, service. |
| Er 2 | Faulty display module cable | |
| Er 3 | Temperature sensor open or shorted | |
| Er 4 | Evaporator sensor open or shorted | |
| Er 6 | Below low alarm setpoint | |
| Er 7 | Above high alarm setpoint | Check door, gasket, condenser. |
ERC112 display (8100-EF, 18600)
| Code | Meaning | What to check |
|---|---|---|
| E01 | Defective air sensor | |
| E02 | Faulty coil sensor | |
| Lo / Hi | Temperature below / above setpoint | |
| LEA | Cooling continuously over 24 h | Resets when compressor cycles off. |
Related service: Commercial Refrigeration Repair in Charlotte, NC